Difference between revisions of "Common problems when using the UP Mini 3D printer"

From WSU Technology Knowledge Base
Jump to: navigation, search
(Created page with "Category:3D Printing Category:UP")
 
Line 1: Line 1:
 +
;Raft peels up from perfboard:
 +
The platform height needs recalibrated.
 +
 +
;Object is peeling up from raft:
 +
This could be a heat issue. Ensure that the door and lid are both kept closed throughout the printing process. To further reduce curling small discs, or curbs  can be added to the models outside of the  corners. This stiffens the model in these areas. These thin discs can later be cut or peeled off the main model.
 +
 +
;Air printing:
 +
The extrusion nozzle is clogged. Contact IT 507 457 5240 option 2. Eric Wright
 +
 +
;Model falls off of raft or perfboard.
 +
The space where the model makes contact with the surface below is too small. Build a small coin shaped disk below your model to make the raft larger and secure the raft and model to the perfboard.
 +
 +
;There is not support at x ### y ###  :
 +
Some part of the model either floats above the printing surface, or passes through it. Use “Auto Placement “ to have the software align the model appropriately.
 +
 +
 +
 
[[Category:3D Printing]]
 
[[Category:3D Printing]]
 
[[Category:UP]]
 
[[Category:UP]]

Revision as of 08:56, 15 April 2016

Raft peels up from perfboard

The platform height needs recalibrated.

Object is peeling up from raft

This could be a heat issue. Ensure that the door and lid are both kept closed throughout the printing process. To further reduce curling small discs, or curbs can be added to the models outside of the corners. This stiffens the model in these areas. These thin discs can later be cut or peeled off the main model.

Air printing

The extrusion nozzle is clogged. Contact IT 507 457 5240 option 2. Eric Wright

Model falls off of raft or perfboard.

The space where the model makes contact with the surface below is too small. Build a small coin shaped disk below your model to make the raft larger and secure the raft and model to the perfboard.

There is not support at x ### y ###  

Some part of the model either floats above the printing surface, or passes through it. Use “Auto Placement “ to have the software align the model appropriately.